|Logo by Liksmaskaren |
(anonymous IP: 126.96.36.199,2057)
Total files: 4297
Full index file
Recent index file
Support the site
KGB Archiver console version ©2005-2006 Tomasz Pawlak, tomekp17()gmail.com, mod by Slawek (poczta-sn()gazeta.pl) based on PAQ6 by Matt Mahoney PAQ6v2 - File archiver and compressor. (C) 2004, Matt Mahoney, mmahoney()cs.fit.edu This program is free software; you can redistribute it and/or modify it under the terms of the GNU General Public License version 2 as published by the Free Software Foundation at http://www.gnu.org/licenses/gpl.txt or (at your option) any later version. This program is distributed without any warranty. USAGE To compress: PAQ6 -3 archive file file... (1 or more file names), or or (MSDOS): dir/b | PAQ6 -3 archive (read file names from input) or (UNIX): ls | PAQ6 -3 archive To decompress: PAQ6 archive (no option) To list contents: more < archive Compression: The files listed are compressed and stored in the archive, which is created. The archive must not already exist. File names may specify a path, which is stored. If there are no file names on the command line, then PAQ6 prompts for them, reading until the first blank line or end of file. The -3 is optional, and is used to trade off compression vs. speed and memory. Valid options are -0 to -9. Higher numbers compress better but run slower and use more memory. -3 is the default, and gives a reasonable tradeoff. Recommended options are: -0 to -2 for fast (2X over -3) but poor compression, uses 2-6 MB memory -3 for reasonably fast and good compression, uses 18 MB (default) -4 better compression but 3.5X slower, uses 64 MB -5 slightly better compression, 6X slower than -3, uses 154 MB -6 about like -5, uses 202 MB memory -7 to -9 use 404 MB, 808 MB, 1616 MB, about the same speed as -5 Decompression: No file names are specified. The archive must exist. If a path is stored, the file is extracted to the appropriate directory, which must exist. PAQ6 does not create directories. If the file to be extracted already exists, it is not replaced; rather it is compared with the archived file, and the offset of the first difference is reported. The decompressor requires as much memory as was used to compress. There is no option. It is not possible to add, remove, or update files in an existing archive. If you want to do this, extract the files, delete the archive, and create a new archive with just the files you want.
|Copyright © 2004-2023 by Björn Hagström All Rights Reserved |